Festo CLR Serie Instrucciones De Utilizacion página 24

CLR−...
Make sure that the maximum permitted loadings are observed during
S
operation:
the tightening torques when fitting the clamping fingers
the values for force F and torque M (see chapter Technical specifications").
In order to fit the clamping finger set:
1. Place the clamping finger on the cone of
the piston rod.
2. Screw the fastening screw into the
threaded hole of the piston rod until the
clamping finger can still just be turned.
3. Fasten the clamping finger with the head
of the screw upwards in a vice (see
Fig. 10).
4. Turn the piston rod at spanner flat 6 until
the alignment corresponds to the individ
ual application.
5. Tighten the fastening screw with the
following torque:
CLR−...
Thread
Tightening
torque [Nm]
Fig. 12
24
12 16 20
M3 M4 M6
1,2 3 12
Fig. 9
Fig. 10
Fig. 11
25 32 40
M6 M8 M8
12 24 24
Festo CLR−... 0406a English
50 63
M10 M10
47 47