Product Overview; Multi-Charger Overview; Battery Power; Battery Charge Notes - Chauvet DJ EZ Pin Pack 4 Guía De Referencia Rápida

Product Overview

Power Switch
AC Power
This product has an external auto-ranging power supply that works with an input voltage range of 100 to 240 VAC, 50/60
Hz. The output voltage is 5 VDC, 2.4 A (4 outputs).
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.

Multi-Charger Overview

USB A Power Port (x4)
(5 VDC, 2.4 A)

Battery Power

Each EZpin product comes with a rechargeable lithium-ion battery for cable-free operation.
The indicator on the EZpin shows red when the battery is charging, and green when it is fully charged.
Do not charge the batteries in a closed container.

Battery Charge Notes

• Avoid depleting the battery below 10%.
• For best results, charge the battery in a temperature between 32 °F (0 °C), and 95 °F (35 °C).
• When charging the battery, keep the product at least 1 m from any open flame or hot plate.
• If the battery is completely discharged, the device cannot be turned on immediately when the charger is
connected. Allow a depleted battery to charge for a few minutes before turning on the device.
• While charging, the device may heat up. This is normal and should not affect the device's lifespan or performance.
If the battery gets hotter than usual, the charger may stop charging.
• Do not charge the batteries in a closed container.
• Do not charge the battery for more than 24 hours.
Battery Run Time
EZpin Pack 4 QRG Rev. 1
QUICK REFERENCE GUIDE
Swivel Base for Pan Adjustment
Safety Loop
Micro USB DC Power Input
Battery Indicator
Maximum Run Time
Up to 10 hours
Magnetic Base
Tilt Adjustment Knob
IR Sensor
Power Plug
Recharge Time
7 hours
EN
2