Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
IN S TA L L AT I O N
Installation
Turn off power to the electrical outlet.
1
Move the unit near the opening. Remove and recycle
2
packing materials.
The 30"
model is shipped with two shipping
(762)
3
brackets located on each side, behind the front face.
Remove both brackets, then reinstall the screws. Refer
to the illustration below.
Plug the power cord into the grounded outlet.
4
Position the oven in the opening and slide back until
5
the mounting flange is flush with the face of the cabinet.
Avoid pinching the power cord between the unit and
cabinet wall.
Open the door. Using the two holes on either side of the
6
mounting flange as a template, drill pilot holes into the
cabinet using a
1
/
" drill bit.
16
Mount the oven using the four screws provided. Refer to
7
the illustration below.
Turn power back on to the electrical outlet.
8
REMOVE
BRACKETS
THEN REINSTALL
SCREWS
Shipping brackets
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf &
Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
MOUNTING
SCREWS
Mounting screws
Troubleshooting
IMPORTANT NOTE:
If the speed oven does not operate
properly, follow these troubleshooting steps:
•
Verify electrical power is supplied to the oven.
•
Verify proper electrical connections.
•
If the oven does not operate properly, contact Wolf
Factory Certified Service. Do not attempt to repair the
oven. Wolf is not responsible for service required to
correct a faulty installation.
wolfappliance.com | 7
Publicidad
Tabla de contenido
