Accessories; Maintenance - Femi NG 120 XL Instrucciones Para El Uso Y Manutencion

4.4 CUTTING CAPACITY (Fig.10)
The table below specifi es the cutting capacity at 0, 45 and
60 degrees which may be obtained in normal conditions of
use described in this manual and without placing any other
object between the jaws of the clamp.
SECTION ANGLE
0 gradi
45 gradi
60 gradi
4.5 CORRECT POSITIONING OF THE PIECE IN THE
CLAMP (Fig. 11)
The pieces to be cut should be fi tted directly between the
jaws without adding other objects.
ATTENTION: Never hold the pieces to be cut in
your hand.
When the pieces to be cut are profi led sections, fl at pieces or
special shapes, refer to the examples shown in the fi gures. If
the thickness of the profi led section is to be very thin, an outline
should be fi tted which copies the profi le inside the profi led
section itself to stop it being crushed between the jaws.
4.6 CUTTING TABLE
5

ACCESSORIES

5.1 CHOISE OF BLADE
Your sawing machine is equipped with a bi-metal blade
measuring 1440x13x0.65 mm with variable, for use in the
majority of cuts possible with this machine.
CUTTING
For special requirements (see Cutting Table point 4.6), for
CAPACITY (mm)
example, for cutting large solid sections or profi led sections
120
or corner pieces of small thickness, blades with different
teeth are also available.
112x112
MATERIAL:
EXTENSION :
HEIGHT:
120x102
THICKNESS:
80
78x78
6

MAINTENANCE

6.1 REGULAR MAINTENANCE
78x78
The operations of ordinary maintenance, which may also
be performed by non-specialist personnel, are all described
50
in the previous sections and here below.
1. Before performing any maintenance operation,
48x48
disconnect the machine electric plug from the wall
outlet.
50x43
2. During maintenance operations, always wear personal
protection (safety goggles and gloves).
3. Remove the processing residues from the cutting area
and the blade guides whenever necessary.
You are advised to use a suction device or a brush.
4. If you do not intend to use the sawing machine
for a long time, clean it and put it in a dry place if
possible.
In these cases it is advisable to slacken off the blade
so that it is not kept tight for no reason.
6.2 ASSISTENCE
Should it be necessary to call qualified personnel for
operations of extraordinary maintenance, or in the case
of repairs, under guarantee or at a later date, you should
always contact an authorized service centre or the factory
directly, if there is no service centre in your area.
6.3 DISPOSAL OF THE MACHINE AND PACKAGING
NFORMATION FOR USERS
In accordance with art. 13 of Legislative Decree
25th July 2005, no. 151 "Implementation
of Directives 2002/95/EEC, 2002/96/EEC
and 2003/108/EEC, relative to reducing the
use of hazardous substances in electrical and electronic
appliances and the disposal of waste", please take note
of the following:
• The crossed out wheelie bin symbol found on the
appliance or on the packaging, indicates that the product
must be disposed of separately from ordinary household
waste when it reaches the end of its working life.
M42 (acciaio per molle + acciaio HSS)
mm 1440
mm 13
mm 0,65
ATTENTION: Do not use jets of compressed
air.
11