Installing Terminal In Panel - Rockwell Automation Allen-Bradley PanelView 550 Instrucciones De Instalación

Installing Terminal in Panel

To install the PV550/PV600 touch screen terminal in a panel:
ATTENTION: Disconnect all electrical power from the panel before
!
making cutout.
Make sure the area around the panel cutout is clear.
Take precautions so that metal cuttings do not enter any components that
may already be installed in panel.
Failure to follow this warning may result in personal injury or damage to
the panel components.
1. Cut an opening in the panel using the panel cutout provided with the terminal.
Remove sharp edges or burrs.
2. Make sure the sealing gasket is properly positioned on the terminal (as shown
below). This gasket forms a compression type seal. Do not use sealing
compounds.
PV550
3. Place the terminal in the panel cutout.
PanelView 550/600 Touch Screen Terminals
Sealing
Gasket
PV600
41061-109-01(B)
7