Radio Reception; Disc Operation - Sony XAV-AX200 Manual De Instrucciones

Ocultar thumbs Ver también para XAV-AX200:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Radio reception

The stations cannot be received.
The sound is hampered by noise.
 The connection is not correct.
– Connect the REM OUT lead (blue/white striped)
or accessory power supply lead (red) to the
power supply lead of a car's antenna (aerial)
booster (only when your car has built-in radio
antenna (aerial) in the rear/side glass).
– Check the connection of the car antenna
(aerial).
– If the auto antenna (aerial) will not extend,
check the connection of the power antenna
(aerial) control lead.
Preset tuning is not possible.
 The broadcast signal is too weak.
RDS
PTY displays [PTY not found.].
 The current station is not a RDS station.
 RDS data has not been received.
 The station does not specify the program type.
Seek starts after a few seconds of listening.
 The station is non-TP or has a weak signal.
– Deactivate TA (page 9).
There are no traffic announcements.
 Activate TA (page 9).
 The station does not broadcast any traffic
announcements despite being TP.
– Tune into another station.
Picture
There is no picture/picture noise occurs.
 A connection has not been made correctly.
 Check the connection between this unit and
other equipment and set the input selector of the
equipment to the source corresponding to this
unit.
 The disc is defective or dirty.
 Installation is not correct.
– Install the unit at an angle of less than 45° in a
sturdy part of the car.
 The parking cord (light green) is not connected to
the parking brake switch cord, or the parking
brake is not applied.
The picture does not fit in the screen.
 The aspect ratio is fixed on the playback source.
There is no picture/picture noise occurs in the
rear monitor.
 The color system setting is incorrect.
– Set the color system to [PAL] or [NTSC]
according to the connected monitor (page 15).
 A picture from the camera is displayed on this
unit.
– No picture appears in the rear monitor if a
picture from the camera is displayed on this
unit.
 Only DVD/USB video playing on this unit can be
displayed in the rear monitor.
 While displaying the picture from the cameras or
car navigation system on this unit, the picture
from DVD/USB video is not displayed in the rear
monitor.
Sound
There is no sound/sound skips/sound cracks.
 A connection has not been made correctly.
 Check the connection between this unit and the
connected equipment and set the input selector
of the equipment to the source corresponding to
this unit.
 The disc is defective or dirty.
 Installation is not correct.
– Install the unit at an angle of less than 45° in a
sturdy part of the car.
 The unit is in pause/reverse/fast-forward mode.
 The settings for the outputs are not made
correctly.
 The DVD audio level is too low (page 11).
 The volume is too low.
 The ATT function is activated.
 The format is not supported.
– Check if the format is supported by this unit
(page 17).
Sound is noisy.
 Keep cords and cables away from each other.

Disc operation

The disc does not play.
 The disc is defective or dirty.
 The disc is not playable.
 The DVD is not playable due to the region code.
 The disc format and file version are incompatible
with this unit (page 17).
 Press  to remove the disc.
Certain functions cannot be performed.
 Depending on the disc, you may not be able to
perform operations such as stop, search, or
repeat/shuffle play. For details, refer to the
manual supplied with the disc.
21
GB

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido