Harbor Breeze 00878 Manual De Instrucciones página 5

ASSEMBLY INSTRUCTIONS
7. Insert receiver from the remote pack (L) into mounting
bracket (A) with the flat side toward the ceiling.
Connect the GREEN/GROUND wire from fan to the
BARE/GROUNDED supply wire. Connect the BLACK
wire (AC IN L) from the receiver to the supply BLACK
wire. Connect the BLACK wire (TO MOTOR L) from
the receiver to the BLACK wire from fan. Connect
the WHITE wire (AC IN N) from receiver to the supply
WHITE wire. Connect the WHITE wire (TO MOTOR
N) from the receiver to the WHITE wire from fan.
Connect the BLUE wire (FOR LIGHT) from receiver
to the BLUE wire from fan.
8. Twist wire ends together and screw wire connectors
(BB) on in a clockwise direction. Tape wire connectors
(BB) and wires together with electrical tape (not
included).
WARNING: Be sure no bare wire or wire strands are
visible after making connection. Place GREEN and
WHITE connections on opposite side of box from
the BLACK and BLUE (if applicable) connections.
The splices should be turned upward and pushed
carefully up into the outlet box.
Hardware Used
BB
Wire Connector
9. Slide the canopy (B) up to the ceiling and over
the two screws on the mounting bracket (A).
Rotate the canopy (B) to lock it in place, then
secure with previously loosened/removed
screws.
7
A
Black
White
White
Ground/Green
Ground/Green
Black
White
8
BB
x 6
9
Outlet box
Lowes.com/harborbreeze
8
ASSEMBLY INSTRUCTIONS
10. Insert blade (H) through the slot in the motor
assembly (F), aligning the three screw holes in
the blade (H) with the screw holes in the motor
Blue
assembly (F). Secure blade (H) using blade
Black
screws (AA).
L Repeat for the remaining blade assemblies.
Hardware Used
F
Blade Screw
AA
11. Remove one of the three screws from the
support plate preassembled underneath the
motor assembly (F). Loosen but do not remove
the other two screws.
Screw
12. Pass the BLUE and WHITE wires from the
motor assembly (F) through the center hole
of the fitter plate (G). Align the two keyslots in
B
the fitter plate (G) with the two screws in the
support plate below the motor assembly (F).
Place the fitter plate (G) over the two loosened
screws and turn the fitter plate (G) clockwise
until it locks. Re-install the previously removed
screw, then tighten all screws securely.
10
x 16
11
Support plate
Screw
12
F
G
Screw
Lowes.com/harborbreeze
9
H
F
H
AA