Important - Harbor Breeze 00878 Manual De Instrucciones

ASSEMBLY INSTRUCTIONS
1. Determine mounting method to use.
A - Downrod Mount
B - Angle Mount
Important: If using the angle mount, check to
make sure the ceiling angle is not steeper than 20˚
2. Remove the mounting bracket (A) from the canopy
(B) by loosening the four screws on the top of the
canopy (B). Remove the two non-slotted screws and
save.
3. Install mounting bracket (A) to outlet box (not
included) by sliding mounting bracket (A)
over the two outlet box screws (not included).
Securely tighten two outlet box screws.
IMPORTANT: If angle mounting, make sure
open end of mounting bracket (A) is installed
facing the ceiling.
1
2
Loosen but
do not remove
Remove
and save
B
3
Outlet box
Lowes.com/harborbreeze
6
ASSEMBLY INSTRUCTIONS
4. Remove the preassembled pin and clip from
downrod (E). Insert downrod (E) through canopy
(B) and yoke cover (D). Thread wires from fan
motor assembly (F) through downrod (E).
5. Loosen the two set screws from the yoke. Slip
downrod (E) into the yoke, then re-insert pin
and clip. Tighten set screws to secure.
A
6. Carefully lift the motor assembly (F) up to the
mounting bracket (A). Install hanger ball on the
top of downrod (E) into opening of mounting
bracket (A). Rotate fan until slot on hanger ball
engages the tab on the mounting bracket (A).
DANGER: Be careful when aligning the tab to
the slot! If not fully engaged, there is a possibility
of fan falling, which may result in serious injury
A
or death.
4
B
D
Clip
Pin
5
Clip
Yoke
Set screw
F
6
Tab
A
E
Lowes.com/harborbreeze
7
E
E
Pin
Slot