Assembly Instructions - Harbor Breeze 00878 Manual De Instrucciones

ASSEMBLY INSTRUCTIONS

13. Remove one of the three screws from the fitter
plate (G). Loosen but do not remove the other
two screws.
14. Connect the BLUE wire from the fan motor
assembly (F) to the BLACK wire from the light fitter
assembly (I) and connect the WHITE wire from the
fan motor assembly (F) to the WHITE wire from the
light fitter assembly (I) by connecting the plugs.
15. Align the two keyslots in the light fitter assembly (I)
with the two loosened screws on the fitter plate (G).
Place the light fitter assembly (I) over the two screws
and turn the light fitter assembly (I) clockwise until it
locks. Re-install the previously removed screw, then
tighten all screws securely.
13
F
G
Screw 2
14
F
G
White
Blue
Black
15
I
Screw 2
Lowes.com/harborbreeze
10
ASSEMBLY INSTRUCTIONS
16. Install bulbs (K) to sockets on light fitter assembly (I).
IMPORTANT NOTE: Your fan has an energy-saving
wattage limiter included. If you replace the bulbs with
more than 190 watts, your fan will automatically turn
off. Ensure bulb wattage is always less than 190 watts!
17. Remove three screws from the side of fitter
plate (G) and save.
I
18. Hang the shade (J) by aligning the hook on
the shade (J) with the hole on the fitter plate
(G). Carefully push up the shade (J), aligning
the screw holes in fitter plate (G) with shade
(J). Re-install the three screws and tighten
securely.
16
I
17
G
Screw
18
G
J
Screw
J
Lowes.com/harborbreeze
11
K