Safety Information - vitapur VWD1066BLS Manual De Uso Y Cuidado

Ocultar thumbs Ver también para VWD1066BLS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Safety Information

Warning:
Warning:
Warning:
Warning:
phthalate (DINP) which is known to the State of California to cause cancer
and Di-isodecyl phthalates (DIDP) which is known to the State of California
to cause birth defects or other reproductive harm.
For more information go to www.p65Warnings.ca.gov
Caution:
direct supervision.
Important:
qualified service personnel only. Before discarding this water
dispenser to landfill, contact local authorities for advice on proper dis-
posal methods for refrigerants.
Note:
Your Vitapur
(low water level sensor) that controls activation/operation of the Kettle Feature
hot water tank heating system. If no water is present and/or low water levels
are detected inside the internal water reservoir, activation/operation of the
Kettle Feature hot water heating system is not possible. Likewise, if the hot
water heating system is operational and water is being drawn simultaneously
causing internal water levels to drop below the established minimal level set
point, hot water tank operation is automatically suspended. To reactivate the
hot water heating system, you must replenish your water supply.
Operation of the cold water system is not affected by this safety feature.
1. Never turn the dispenser upside down or tilt more than 45 degrees. If the unit has
been resting on its' side for a long period of time, place the water dispenser in the
upright position for approximately 12 hours before turning it on.
2. For use with 3, 4 or 5 gallon (12, 15 or 19 liter) water bottles.
3. Never use this dispenser with water that is unsafe to drink or is from an unknown
source.
4. Never use any other liquid in the dispenser other than known and microbiologically
safe bottled water.
5. This water dispenser is equipped with a grounded power cord plug for your safety.
6. Keep your water dispenser in a dry place away from direct sunlight.
7. Leave a minimum of 2" (5 cm) around the back and sides of the dispenser for proper
ventilation.
8. Always install your water dispenser on a level floor. Wait 3 minutes before restarting
machine after shutting it down.
9. Always unplug the water dispenser before servicing.
10. Regular cleaning of your water dispenser is required for your warranty. Please
follow the cleaning instructions outlined in this manual and clean the dispenser
every 4 months.
Never put anything flammable close to the dispenser
This water dispenser is designed for indoor applications only.
Do not damage the refrigeration cooling system.
This Product can expose you to chemicals including Diisononyl
Never allow children to dispense hot water without proper and
Refrigerants must be handled and disposed of by
water dispenser is designed with a special safety feature
®

Publicidad

Tabla de contenido
loading

Tabla de contenido