Jøtul FS 44 Instrucciones Para Instalación página 23

20. Rotate the smoke bell to the desired position (fig. 25). Tighten
the screws.
21. Replace the exhaust deflector (fig. 7A) and baffle (fig. 7B).
Position the rear burn plate (fig. 6F) between the ribs of the
rear plate. The side burn plates (fig. 6E) should be inserted
at an angle at the front edge and then swivelled into the
back edge. The air duct (fig. 6D) and log retainer (fig. 6C) are
positioned last.
22. Then position the ventilation element. Position the grate over
the opening.
23. Fit the flue pipe in accordance with the instructions.
Open model - the low upper part consists of
the following parts:
Part 5: Ventilation element
Part 6: Grate
Part 7: Sides
1. Position the sides (parts 7) over the Basic module. Check they
are level using a spirit level and adjust as necessary using
adhesive or mortar.
2. The ventilation element (part 5) should then be placed on
top of the sides.
3. The grate (part 6) should be positioned in the air opening on the
ventilation element.
Open model - the high upper part consists of
the following parts
Part 2: Sides, (high)
Part 5: Ventilation element
Part 6: Grate
1. Position the sides (part 2) over the Basic module. Check they
are level using a spirit level and adjust as necessary using
adhesive or mortar.
2. The ventilation element (part 5) should then be placed on
top of the sides.
3. The grate (part 6) should be positioned in the air opening on the
ventilation element.
Closed model - the upper part consists of the
following parts
Part 6: Grate
Part 8: Complete base/cowl
Part 9: Sealing plug
1. Position the cowl (part 8) over the side panels (part 4). Check
they are level using a spirit level and adjust as necessary using
adhesive or mortar.
2. The ventilation element (part 5) should then be placed on the
top of the cowl.
3. The grate (part 6) should be positioned in the air opening on the
ventilation element.
qty. 1
qty. 1
qty. 2
qty. 2
qty. 1
qty. 1
qty. 1
qty. 1
qty. 1
The low bench consists of the following
parts:
Part 1: Bottom plate/shelf plate qty. 2
Part 7: Sides, (low)
1. The bottom plate/shelf plate (part 1) should be placed on the
floor surface. Check it is level using a spirit level and adjust as
necessary using adhesive or mortar. It is extremely important
that the bottom plate/shelf plate be steady and level.
2. Position the sides (parts 7) on the bottom plate/shelf plate.
3. Position the bottom plate/shelf plate on top.
The high bench consists of the following
parts:
Part 1: Bottom plate/shelf plate qty. 2
Part 2: Sides
1. The bottom plate/shelf plate (part 1) should be placed on the
floor surface. Check it is level using a spirit level and adjust as
necessary using adhesive or mortar. It is extremely important
that the bottom plate/shelf plate be steady and level.
2. Position the sides (parts 2) on the bottom plate/shelf plate.
3. Position the bottom plate/shelf plate on top.
english
qty. 2
qty. 2
23