Turnstone Bivi Manual Del Usario página 5

Attach Leg to Trough
TIP:
Rest one side of the trough on the floor
and place lip on the other side into the bottom
edge of the leg.
NOTE: For the "Table for One", place the trough
to the far end, see page 9.
3.
Stand one leg up. Lift and place end of electrical
trough up to the leg. Drop the lip of the trough into
the slot on the leg (3a). Make sure the connection
bracket is fully engaged with the top leg slot (3b).
Tighten with hex wrench to 55-70 in-lbs (6.2-8 Nm) (3c).
TROUGH IS TO BE CENTERED
IN ORDER TO CORRECTLY CONSTRUCT TABLE,
TROUGH MUST BE EXACTLY CENTERED
NOTE: You must loosen connection
bracket prior to install
ELECTRICAL
TROUGH
3a
LIP
SLOT
3b
CONNECTION
BRACKET
View from Underneath
ELECTICAL TROUGH
LEG
TOP SLOT LEG
HEX WRENCH
3c
Page 5 of 13
70525 Rev C