Preparation And Taking Into Operation; Inserting Rechargeable Batteries - Reiner jetStamp 1025 Instrucciones De Empleo

jetStamp 1025

1. Preparation and Taking into Operation

1.1. Commissioning
The rechargeable batteries must be charged completely before the first use.
The charging time is approx. 3 hours. The rechargeable batteries are charged when the
green charge display
Only connect the device to the PC after the PCset graphic software has been installed,
otherwise the installation of the device drivers will fail!

Inserting rechargeable batteries

Always replace all rechargeable batteries at once. Date, time and counter reading of the
numbering machine are retained when the rechargeable batteries are removed.
Open the flap for battery and print cartridge compartment
f
Push battery compartment locking
f
Open battery compartment
f
Close battery compartment
f
Close flap for battery and print cartridge compartment
f
Charge the rechargeable batteries
Connect the power supply unit of the device to the socket for power supply unit
f
charging indicator
indicator goes out.
Inserting printing cartridge
Depending on ink type used, different Protective Nozzle Seals are required.
Use sealing of the enclosed printing cartridge.
Switch the unit on via the ON/OFF button
f
The operating status LED
Press function key for print cartridge
f
change position.
Open flap for battery and print cartridge compartment
f
Push the print cartridge locking
f
Remove the print cartridge
f
ing instructions for the print cartridge P5).
Place the unit on a firm surface.
f
Hold pressure cartridge locking
f
9
14
goes out.
Fig.

20
upwards until the locking can be opened.
19
, ensure correct polarity and insert batteries.
19
.
Fig.

14
is lit. The charging process is completed as soon as the charging
Fig. B +

4 lights up green.
5
. Print carriage
21
slightly upwards and open it.
8
from the packaging and remove the dust cover (see operat-
21
in place.
B C +
G
+
6
.
6
.
B
E + C
3
.
7
moves to the right into the
6
.
15
. Green