Preparation And Taking Into Operation; Commissioning - Reiner jetStamp graphic 970 Manual De Instrucciones

jetStamp graphic 970

1. Preparation and Taking into Operation

1.1. Commissioning

The rechargeable batteries must be charged completely before the first use.
The charging time is approx. 3 hours. The rechargeable batteries are charged when
the green charge display
Inserting rechargeable batteries
Always replace all rechargeable batteries at once. Date, time and counter reading of the
numbering machine are retained when the rechargeable batteries are removed.
Open battery compartment
f
Place the textile ribbon flat across the compartment.
f
Ensure correct polarity and insert the rechargeable batteries.
f
2
Close battery compartment.
f
The textile ribbon serves simpler removal of the rechargeable batteries.
Charge batteries
Only connect the device to the PC when the PCset graphic-Software was installed
(see Install PCset graphic Software" Page 48).
Charging at a USB hub without dedicated power supply is not possible.
Connect the Micro-USB socket of the device
f
connect the mains unit to the mains.
46
8
goes out.
 Fig.
2
.
C
 Fig.
A
9
to the mains unit with the USB cable and