Preparation; Supplied Accessories; Attaching The Stand Unit - Pioneer KURO KRL-46V Manual Del Usuario

preparation

Supplied accessories

Remote control unit
(g1)
TV
INPUT
1 2 3 4
5 6 7 8
TV DTV RADIO
1 2 3
4 5 6
7 8 9
INFO
0 P.INFO
CH RETURN
P
DVD TOPMENU/
EXIT GUIDE
EPG
ENTER
HOME
MENU RETURN
MENU
HDMI REC STOP
CTRL
SCREEN AV
CM SKIP SIZE SELECTION
TOOLS DVD HDD
SOURCE SELECT
TV DVD
STB DVR VCR
Pages 3 and 11
• Operation manual (This publication)
• Warranty card

attaching the stand unit

• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Before performing work, spread cushioning over the surface on which you will be laying the TV. This will prevent
it from being damaged.
Caution
attach the stand in the correct direction.
•
• Be sure to follow the instructions. incorrect installation of the stand may result in the tV falling over.
1
Confirm that there are eight screws (four short
screws and four long screws) with the stand
unit.
2
Attach the supporting post for the stand unit
onto the base using the four long screws with
the hex key (supplied) as shown.
0
AC cord (g2)
Page 14
•
3
Hex key
Long
screw
note
•
Cable clamp (g1)
Page 14
"AA" size alkaline battery (g2) ... Page 11
1 Insert the stand into the openings on the
bottom of the TV. (Hold the stand so it will
not drop from the edge of the base area.)
2 Insert and tighten the four short screws into
the four holes on the rear of the TV
Hex key
Short
screw
Soft
cushion
To detach the stand unit, perform the steps in reverse
order.
Stand unit (g1)
Page 10