Atlantis A03-S1000LE Manual De Instrucciones página 26

A03-S1000LE
On the front panel You can found 1 LED for an easy diagnostic.
LED
Main Switch [
Acoustic Alarm
Sound disable (please use the SW).
PV mode.
Setting Item.
Information
] Press the UPS On/OFF [
seconds, then the Buzzer sounds twice/3 times, the
UPS will be start-up/Switch OFF. The power on
indicator light will illuminate (blue).
To enable "DC-Start" Function when Utility fails. (To
enable DC Start properly, you are recommended to
connect <80% output load with the UPS only). P.S.
Make sure the computer connected to the UPS is
switched on before enable the "DC-Start" function.
You are not recommended to add some other
computer or peripherals after DC-Start function is
activated.
Alarm setting: The audible alarm can be turned OFF
or ON by quickly pressing the POWER button twice.
The default setting is for the Alarm On. To turn the
Alarm Off, quickly press the power button twice. You
will hear two short beeps when the Alarm is turned
off. To turn the Alarm back on, quickly press the
power button twice. You will hear a single short beep
when the Alarm is turned on.
Battery
seconds).
UPS is in battery low condition (buzzer alarms
every 2 seconds).
OverLoad (buzzer alarms twice in a second).
Fault (buzzer alarms continuously).
Mode (buzzer
26
] Switch for approx. 2/3
alarms every
ENG
30