Management Sw; Battery And Ics; Support - Atlantis A03-S1000LE Manual De Instrucciones

A.1.2 Management SW
Situation
How to install the

Management SW.

PC doesn't find the
UPS.
A.1.3 Battery and ICS
Situation
Backup time
Wich type of battery
does UPS use?
How often do I have
to change battery?
Where can I find
batteries?
How can I check the
ICS?
A.1.4 Support
For technical questions and support, please contact our help-desk by ticket on
http://www.atlantis-land.com/ita/supporto.php.
send an e-mail to info@atlantis-land.com. For presales informations, please send an
e-mail to prevendite@atlantis-land.com.
Atlantis
Fax: +39.02.78.62.64.39
Website: http://www.atlantis-land.com
Email: info@atlantis-land.com
Download and install the management SW. Once started the
UPS you can connect it to PC through USB cable. At this time
the SO detects and installs automatically all drivers.
1. Check if the cable is properly connected
2. Use the original cable
3. Close and lauch again the management SW.
The battery backup time (sometime called battery reserve
time or battery autonomy) is the length of time the battery
will supply power to the load during a power failure. You can
check on the Appendix Backup Time.
 2 x 12V/7Ah (A03-S1200)
 2 x 12V/4.5Ah (A03-S1000LE)
Atlantis recommends to replace the batteries once a year.
1. please contact Your reseller.
2. please contact directly Atlantis.
The circuit breaker provides optimal overload protection. If
an overload is detected, an audible alarm will sound and the
unit will emit one long beep. To correct this, turn the UPS off
and unplug at least one piece of equipment from the battery
power supplied outlets. Wait 10 seconds. Make sure the
circuit breaker is normal and then turns the UPS on.
30
Solution
Solution
For generic informations, please
ENG