Controls; Remote Control - Haier QHEK08AC Instrucciones De Instalación Y Manual Del Usuario

CONTROLS

Features and appearance will vary.
Lights beside the touch pads on the air conditioner control panel
indicate the selected settings.
1 2 3
Air Conditioner Controls
1. Power Pad
Turns air conditioner on and off. When turned on, the
display will show the Set temperature.
2. Display
Shows the Set temperature or time remaining on the
Delay timer. Shows the Set temperature while setting the
temperature in Cool or Eco modes.
3. Temp and Delay Increase /Decrease Pads
Use to set temperature or delay time. Temperature can be
set in Cool and Eco mode.
4. Mode Pad
Use to set the air conditioner to Fan Only, Cool, or Eco
mode.
5. Fan Speed Pad
In Cool or Eco mode: Use to set the fan speed to Auto,
High, Med or Low on the unit.
In Fan Only mode: Use to set the fan speed to High, Med,
or Low on the unit.
6. Delay Pad
(set by remote control only)
Delay ON—When the air conditioner is off, it can be set
to automatically come on in 1 to 24 hours at its previous
mode and fan settings.
Delay OFF—When the air conditioner is on, it can be set to
automatically turn off in 1 to 24 hours.
How to set:
Press the Delay pad on the remote control. Each touch of
the Increase / Decrease pads on the remote control will
set the timer in 1-hour intervals.
To review the remaining time on the Delay timer, press
the Delay pad on the remote control. Use the Increase /
Decrease pads on the remote control to set a new time if
desired.
To cancel the timer, press Decrease pad on the remote
control until the set time is zero.
6
4 8
MODE COOL FAN ECO FILTER
SPEED AUTO LOW MED HIGH WIFI
5 9
7
SLEEP
Solid light indicates WiFi
connected
Blinking light indicates
connecting
See Appliance Communication
section in this manual
7. Sleep Pad
(set by air conditioner controls only)
The SLEEP mode sets the unit to gradually change
settings over an 8 hour period to allow for some
increased energy efficiency during sleep hours.
The SLEEP mode is available only in COOL and FAN only
settings.
Press the SLEEP mode pad and its light will illuminate.
The fan indicator will stay at the same setting but the air
conditioner will automatically change the FAN speed to
low in either COOL or FAN only mode.
In FAN only mode, the fan will stay in the LOW speed
setting for 8 hours. After 8 hours, the air conditioner will
resume the settings that were in place before the SLEEP
mode pad was pressed.
In COOL mode, the fan will stay in the LOW speed
setting for 8 hours from the time the SLEEP mode pad
was pressed. The air conditioner will also raise the set
point 2°F in 30 minutes and 2°F more in another 30
minutes where it will remain for the next 7 hours. After 8
hours, the air conditioner will resume the settings that
were in place before the SLEEP mode pad was pressed.
While the unit is in SLEEP mode, pressing any pad will
return it to the settings that were in place before the
SLEEP mode pad was pressed.
8. Filter Reset Pad
This feature automatically notifies you that the air filter
must be cleaned. The indicator light will come on after 240
hours of operation. Clean the air filter (refer to page 6),
place it back in the front panel, and press the Filter Reset
pad. The light will go off.
9. Wi-Fi Pad
Enables connection of the air conditioner to the home
WiFi.
Download the SmartHQ
For details go to Haierappliances.com.
1
Power
5
Speed
3
4
Mode
6
Eco Delay

Remote Control

49-5000529 Rev. 0