Ryobi RBC254SESO Manual De Utilización página 39

TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM
Engine will not start. No spark.
No fuel.
Engine is flooded.
Start rope is harder to pull now
than when it was new.
Old fuel.
Engine starts but will not Engine requires approximately
ac cel er ate. three minutes to warm up.
Engine starts but will Carburetor requires adjustment.
only run at high speed at
half choke.
Engine does not reach Check lubricant fuel mixture.
full speed and emits
ex ces sive smoke.
Air filter is dirty.
Spark arrestor screen is dirty.
Engine starts, runs, Idle speed screw on carburetor
and accelerates but will requires adjustment.
not idle.
Blade continues to rotate Carburetor requires adjustment.
at idle speed.
Line will not advance. 1. Line welded to itself.
2. Not enough line on spool.
3. Line worn too short.
4. Line tangled on spool.
5. Engine speed too slow.
English (Original instructions)
POSSIBLE CAUSE
The spark plug may be damaged, remove it and check for dirt
and cracks. Replace with a new spark plug.
Push primer bulb until bulb is full of fuel. If bulb does not fill,
primary fuel delivery sys tem is blocked. Con tact a servicing
dealer. If prim er bulb fills, engine may be flooded, proceed to
next item.
Remove spark plug, turn product so spark plug hole is aimed
at the ground. Rotate the choke lever to "
starter cord 10 to 15 times. This will clear excess fuel from
en gine. Remove any fuel which splashed on the product. Clean
and reinstall spark plug. Clean up any spilled fuel and move at
least 9m away before restarting. Pull starter three times with
choke lever at "
to "
still fails to start, repeat pro ce dure with a new spark plug.
Contact a servicing dealer.
Only use fresh fuel mixed with recommended oil. Fuel over 30
days old may prevent the product from starting.
Allow engine to completely warm up. If engine does not
accelerate after three minutes, contact a ser vic ing dealer.
Contact a ser vic ing dealer.
Use fresh fuel and the correct 2-stroke lubricant mix.
Clean air filter. Refer to Clean ing the Air Filter earlier in this
manual.
Contact a servicing dealer.
Contact a servicing dealer.
Contact a servicing dealer.
1. Lubricate with silicone spray.
2. Install more line. Refer to "Line Replacement" earlier in this
3. Pull lines while alternately pressing down on and releasing
4. Remove line from spool and rewind. Refer to "Line
5. Advance line at full throttle.
37
SOLUTION
". If en gine does not start, rotate choke lever
" position and repeat normal starting pro ce dure. If engine
manual.
bump head.
Replacement" earlier in this manual.
" position and pull