Operating Instructions - Argo narcis Manual De Uso

OPERATING INSTRUCTIONS

● Start Operation
1) Ensure that the unit is connected to the power socket.
2) Make sure the water tank is placed in proper position. (After plug
on the machine for the first time, if the full tank lamp light up, just
pull out the water tank then push it back to the proper position.)
3) Turn clockwise the humidity control knob to the suitable humidity
(usually at normal position). If the humidity indoor is over the set
humidity, then the machine will start removing moisture.
●Please turn the humidity control knob to the position of "continuous"
to make the machine working continuously when exploded to a high
humidity environment.
4) When the humidity in the room reached the set humidity then the machine will
stop operating.
5) When the humidity in the room is over the set humidity then the machine will
start removing moisture again.
6) The alternance between point 3). 4). 5) is controlled by the set humidity.
When RED Full Tank Light is On
●
When the water tank is full, the red light will light up, the dehumidifier will stop
operating. Remove the water from the tank, then place the water tank back to its
proper position and the machine will start operating again.
DEFROST
●
When operating in low temperatures (less than 12°C) the surface of the evaporator will accumulate frost
and effect the efficiency of the dehumidifier. When this happens the machine will go into periodic defrost
mode automatically. This is quite normal. Defrost light will come on. The unit will operate in
temperatures down to 5°C. Defrost time may vary. If the dehumidifier freezes up turn the unit off for few
hours and then restart. It is not recommended to use the dehumidifier in temperatures below 5°C.
EMERGENCY
Please unplug the machine when there is sometime wrong.
Contact the service agent immediately
.
Do not disassemble the dehumidifier yourself！
Remove the water in the water
tank with two hands
-2-