Operating Precautions - Argo DRY PURY 25 Instrucciones De Uso

Green filter - Catechin filter natural substance extracted from tea, eliminates odors and pollutants
Gray filter - Silver ion filter, eliminates bacteria
Blue filter - Additional filter with anti-bacterial action
The dehumidifier is equipped with a signaling system for the need to clean the dust filter after 250 hours of
operation (AIR CLEAN SYSTEM).

OPERATING PRECAUTIONS

The appliance will only start operating if the humidity level in the room is above the set value.
The dehumidifier will continue to operate until the set humidity level has been reached, with the exception of
interruptions caused by a full tank. In this case, empty and reinstall the tank: the dehumidifier will now start running
again.
WARNING:
After each interruption of its operation, at least 3 minutes must pass before the dehumidifier starts up again:
this delay prevents the compressor being damaged.
If, on the other hand, the set humidity percentage is higher than the level currently found in the room, the
dehumidifier will not start.
If, after following the appliance start-up instructions, the dehumidifier does not start and the stand-by (POWER) LED
does not come on, or if the dehumidifier stops for no reason, make sure the plug and power cord are in good working
order. After doing so, wait for 10 minutes and then restart the appliance.
If the dehumidifier still does not start after 10 minutes, or if either the power cord or plug are damaged, switch off the
appliance and contact an after-sales service centre.
WARNING:
When the dehumidifier is running, the compressor produces heat and the appliance emits warm air into the
room. The room temperature will therefore tend to increase. This is completely normal.
TURNING THE DEHUMIDIFIER OFF
To turn the dehumidifier off press the POWER button.
The power supply stops and the compressor stops, even if the ventilation function continues for about 3 minutes, before
stopping, then the dehumidifier stops working. Unplug the appliance if you do not intend to use it for some time.
HOW TO ELIMINATE CONDENSATE
The water extracted from the air can be collected in the provided water tank.
When the tank is full, not inserted or not correctly inserted, the FULL TANK led turns on and the unit beeps for about 10
seconds, at the end of which the unit turns off.
Do not use remove the water tank while unit is in operation or if it has just been turned off.
To switch off the appliance, press POWER button and wait a few seconds.
V 07/20 23