General Information; Unpacking; Accessory Box; Assembly - Generac GP Serie Manual Del Propietário

General Information

1.1 UNPACKING

• Remove all packaging material.
• Remove separate accessory box.
• Remove the generator from carton.

1.1.1 ACCESSORY BOX

Check all contents. If any parts are missing or damaged locate an
authorized dealer at 1-888-436-3722.
Contents Include:
• 1 – Owner's Manual
• 1 - Quart Oil SAE 30

Assembly

• 2 - Never-Flat Wheels
• 1 - 12 volt Adapter Plug Charger*
• 1 - Hardware Bag (containing the following):
2 - Rubber Feet
2 - 5/16" Flat Washers
4 - 5/16" Carriage Bolts
2 - 1/2" Axle Bolts
2 - 1/2" Flat Washers
* Electric start units only.
1.2 ASSEMBLY
The generator requires some assembly prior to using it. If
problems arise when assembling the generator, please call the
Generator Helpline at 1-888-436-3722.

1.2.1 ASSEMBLING THE ACCESSORY KIT

The wheels are designed into the unit to greatly improve the
portability of the generator.
The wheels are not intended for over-the-road use.
1. Refer to Figure 1 and install Wheels as follows:
• Slide the 1/2" Axle Bolt through the 1/2" Flat Washer, Wheel
and Wheel bracket on frame.
• Install 1/2" Locking Flange Nuts onto 1/2" Flange Bolt.
2. Refer to Figure 1 and install Frame Foot, Foot Support and
Rubber Feet as shown.
• Slide Rubber Foot stud through Frame Foot and Foot
Support; Install 5/16" Locking Flange Nuts Slide 5/16" Bolt
through 5/16" Flat Washer and then through holes in Frame
Rail.
• Slide Frame Foot onto 5/16" Bolts; Install 5/16" Locking
Flange Nuts.
3. Refer to Figure 2 and install Handles as shown.
• Remove top Curved Head Bolts and Cap Nuts (Cap Nuts will
be re-used).
• Slide Handle Assembly over Frame Tube, aligning 2 holes.
• Slide 5/16" Carriage Bolts through; Install 5/16" Cap Nuts.
4
• 1 - Left Handle Assembly
• 1 - Right Handle
• 1 - Frame Foot
• 1 - Foot Support
2 - 5/16" Bolts
4 - 5/16" Locking Flange Nuts
2 - 5/16" Locking Cap Nuts
2 - 1/2" Locking Flange Nuts
NOTE:
Figure 1 – Wheel Assembly
FOOT SUPPORT
Figure 2 – Install Handle Kit

1.2.2 BATTERY CONNECTION (ELECTRIC START ONLY)

• Caution must be taken when connecting the battery.
The battery shipped with the generator has been fully charged.
A battery may lose some of its charge when not in use for
prolonged periods of time. If the battery is unable to crank the
engine, plug in the 12V charger included in the accessory box
(see section "Charging a Battery"). RUNNING THE GENERATOR
DOES NOT CHARGE THE BATTERY.
• Cut the tie wrap cable holding the RED battery cable to the
stator.
• Connect the RED battery cable to the starter motor terminal.
After making sure that the connection is tight, slip the rubber
boot over the terminal connection. See Figure 3.
FOOT
NOTE: