Disconnect The Terminal; Remove The Existing Terminal - Rockwell Automation Allen-Bradley 2711P-RAK4 Instrucciones De Instalación

4 Cutout Adapter Kit

Disconnect the Terminal

1. Disconnect power at the source and remove the power cord from the
PanelView terminal.
2. Disconnect all communication cables from the terminal.
ATTENTION
!

Remove the Existing Terminal

1. Remove the self-locking nuts that secure the terminal to the panel.
2. Slide the existing terminal out from panel.
Publication 2711P-IN020A-MU-P
Make sure the power cord of the PanelView terminal is
disconnected and that all cables have been
disconnected from the terminal.