Attach The Adapter Plate To The Panel - Rockwell Automation Allen-Bradley 2711P-RAK4 Instrucciones De Instalación

Attach the Adapter Plate to the Panel

1. Align the studs on the cutout adapter plate with the existing stud holes on
the front of the panel.
2. Place the adapter plate into the front of the panel cutout until the sealing
gasket material is firmly against the front of the panel.
Inside of Panel or
Enclosure
3. Using the supplied nuts with lock washers, fasten the cutout plate onto the studs until
the sealing gasket is slightly compressed against the front of the panel.
4. Using the torque wrench, tighten the nuts to not more than 1.36 N•m
(12 in-lb) to maintain a NEMA Type 4X rating. Do not overtighten.
Nut and Washer
Cutout Adapter Kit
Front Adapter Plate
Front of Panel or Enclosure
Publication 2711P-IN020A-MU-P
5