Attach Terminal To The Adapter Plate - Rockwell Automation Allen-Bradley 2711P-RAK4 Instrucciones De Instalación

6 Cutout Adapter Kit

Attach Terminal to the Adapter Plate

1. Insert the new terminal into the front of the enclosure until the terminal gasket is
flush with the adapter plate.
Nut and Washer
Adapter Plate
2. Insert 4 mounting levers into the mounting slots of the terminal (as shown below).
Slide each lever until flat side of lever touches the surface of the panel.
Mounting Slots
3. When all levers are in place, slide each lever an additional notch or two until you hear
a click.
Publication 2711P-IN020A-MU-P
Mounting Levers
Flat Side of Lever
Rear of Panel or
Enclosure
Rear of PanelView Plus
400 Keypad or 600
Touch Terminal
Mounting Lever