Important; Pre-Installation Information; Assembly Of Components - Bradley S19-300T Instalación

S19-300T, S19-300B
Read this installation manual completely to ensure proper installation, then file it with the owner
Installation
or maintenance department. Compliance and conformity to drain requirements and other local
codes and ordinances is the responsibility of the installer.
Separate parts from packaging and make sure all parts are accounted for before discarding
Packing List
•
any packaging material. If any parts are missing, do not begin installation until you obtain the
•
•
IS
T H
E
•
S ID
U P missing parts.
Flush the water supply lines before beginning installation and after installation is complete. Test
the unit for leaks and adequate water flow. Main water supply to the eyewash should be "ON" at
all times. Provisions shall be made to prevent unauthorized shutoff.
The ANSI Z358.1 standard requires an uninterruptible supply of flushing fluid at a minimum 30
PSI (0.21 MPa) flowing pressure. Flushing fluid should be tepid per ANSI Z358.1.
The inspection and testing results of this equipment should be recorded weekly to verify proper
operation. This equipment should be inspected annually to ensure compliance with ANSI Z358.1.
Workers who may come in contact with potentially hazardous materials should be trained
P.O. BOX 309, MENOMONEE FALLS, WI 53052-0309 USA
TEL: 1-800-BRADLEY FAX: (262-251-5817)
http://www.bradleycorp.com
114-051
regarding the placement and proper operation of emergency equipment per ANSI Z358.1.
For questions regarding the operation or installation of this product, visit www.bradleycorp.com
or call 1-800-BRADLEY.
Product warranties and parts information may also be found under "Products" on our web site at
www.bradleycorp.com.
Components
2
Heat Trace Unit
S19-300T (top supply)
S19-300B (bottom supply)
9/26/08

IMPORTANT

Parts List
Item 11
Eye/Face Wash
Assembly
S05-153
114-052 (qty. 2)
Pull Rod
128-156G
Bradley Corporation • 215-1082 Rev. F; ECN 08-521
11.11
Parts List
Item 11
11.1
Plastic Showerhead Kit
Optional Stainless
S24-188
Steel Showerhead Kit
Prepack S45-1535
R
P.O. Box 309, Menomonee Falls, WI 53051
TEST THIS UNIT EACH WEEK
DIESES GERÄT 1ST WÖCHENTLICH ZU PRÜFEN.
ESSAI HEBDOMADAIRE
Test-operate valve(s) each week and sign below.
Report any malfunctions immediately.
Ventil(e) wöchentlich im Testbetrieb prüfen, bestätigt
durch Unterschrift. Jegliche Störung sofort melden.
Test le fonctionnement des valves chaque semaine et
signe en bas. S'il y à quelque chose qui ne va pas fait
un rapport immédiatement.
Date Signed Date Signed
Datum Unterschrift Date Signed
Date Signe Date Signed
P.O. BOX 309, MENOMONEE FALLS, WI 53052-0309 USA
TEL: 1-800-BRADLEY FAX: (262-251-5817)
http://www.bradleycorp.com
114-052
Safety Sign
Emergency Tag
204-421
Hex Nut #10-24 Screw #10-24 x 1/2"
151-001 (qty. 2) 160-245 (qty. 2)
Installation
11.12
11.1
11.21
11.2
S24-189
Hook
151-001 (qty. 2)
Wire Nut
P10-111 (qty. 2)