Detergent Application - Campbell Hausfeld IN459000AV Instrucciones De Uso

Operation (Continued)
doors are closed tight. In addition, you should
make sure that all plants and trees adjacent to
the cleaning area are protected by a drop cloth.
This will ensure that your plants won't be
sprayed by the detergents.
2. Initial High Pressure Rinse
The next step is to spray the cleaning surface
with water to clear off any dirt or grime that
may have collected on the surface. This will allow
your detergent to attack the deep down dirt
that has worked its way into the cleaning sur-
face. Before triggering the gun, adjust the noz-
zle to a wide fan pattern and slowly adjust to
the desired spray pattern. This will help you
avoid applying too much concentrated spray to
the surface which could cause damage.

3. Detergent Application

USE THE INSTRUCTIONS APPROPRIATE
FOR MODEL PURCHASED
NOTE:
Use only detergents formulated for pres-
sure washers.
NOTE:
Test detergent in an inconspicuous area
before use.
Figure 9 – Detergent application
Units with Detergent Applicator
Included
Follow manufacturer's label directions for mixing
correct concentrations of soap/detergents. The
soap/detergent to water ratio through the pres-
sure washer is approximately 5.4% (1 to 19).
MODELS WITHOUT DETERGENT TANK
Figure 10 – Detergent Applicators
1.Unscrew top of detergent applicator and fill
applicator with detergent.
2.Replace top on applicator.
3.Remove lance from gun.
4.Attach detergent applicator to gun. (See Figure
11.)
Figure 11 – Attach applicator to gun
5.For detergent applicators that fit on end of
lance, turn lance to obtain wide fan pattern.
(Detergent suction will not work when
lance is adjusted to provide a narrow pat-
tern.) Connect applicator to end of lance.
Make sure connection is secured correctly. (See
figure 12.)
Figure 12 – Turn lance to obtain wide fan
pattern.
7
OR
www.chpower.com