Installation Instructions - Zoeller 1052 Manual Del Usuario

INSTALLATION INSTRUCTIONS

1. Make sure the sump basin is cleared of any
debris or sediment, and place the sump pump
on a hard surface inside the basin.
2. Connect the discharge pipe, fittings, and check
valve (not provided) to pump discharge. The
discharge pipe should be the same size as the
discharge of pump (1-1/2-in) or larger.
NOTE: Make sure there is enough room in the
basin for the float to move freely. If the float is
restricted, the pump will not operate.
3. Drill a 3/16-in vent hole in the discharge pipe,
level with the top of pump. Pumps have a vent
located in the pump, but an additional vent hole
is recommeded. It is normal for water to spray
from this hole when the pump is operating.
1
2
3
3/16-in
Vent hole
5
© 2020. All rights reserved.
Discharge pipe
and ttings
Check
valve