Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CABINET CONSIDERATIONS AND COUNTERTOP CUTOUT
Dimension requirements in Figs. 1
& 2 are for combustible surfaces,
When the surface is protected by a
material listed by UL as a Floor
Protector and Wall Shield covered
with not less than No. 28 MSG sheet
metal 0.015 inch stainless steel,
0.024 inch aluminum or copper, it
is considered noncombustible and
some dimensions may be reduced.
For a noncombustible surface over
the cooktop, the minimum
clearance is 24" rather than 30".
•
Instructions are based on
Standard American cabinets 36"
high x 24" deep with a 25"
countertop.
•
Provide approximately a 10
square inch opening in the toe
kick area or other cabinet area
for adequate air inlet to the
cabinet.
Figure 2
6" Min. to
Left Side Wall
1
/
" Min.
8
Clearance
From Cooktop
to Start of
A
Radius
7
1-
/
" Min. to
8
Counter Front
Cutout Dimensions are Underlined
Figure 1 – Installed Dimensions (from cooktop edges)
Dimensions are minimum clearances to combustible materials
NOTICE: All measurements
given have to be precisely followed.
If nonstandard cabinets are used,
make sure they are installed with
minimum dimensions shown in fig.
1 and fig. 2.
3
1
/
" Min. to
4
Combustible Wall
1
7-
/
" Min. to
8
Left Side Wall
Cooktop to front of countertop – 0" minimum
3" Min. to
Right Side Wall
21 ½" Cooktop
4" Below Countertop
B
C
D
Cooktop
A
Cut-out
B
Cut-out
C
Corner
D
Overall
PAGE 2
Plan the installation of the unit so
that the power cord, gas shut-off
valve and gas pressure regulator are
accessible from the front of cabinet.
If a drawer is installed directly under
the cooktop, its depth (front to
back) should be no greater than 15".
1
4-
/
" Min. to
8
Right Side Wall
30" Models
36" Models
45" Models
19-1/8" to
19-1/8 to
19-1/8 to
19-7/8"
19-7/8"
19-7/8"
28-15/16" to
34-15/16" to
43-15/16" to
29-3/8"
35-3/8"
44-1/2
30"
36"
45"
31"
37"
46"
Publicidad
Tabla de contenido
