Installing The Cooktop - Thermador SGS304 Manual De Instrucciones De Instalación

INSTALLING THE COOKTOP

1. Seal the Cooktop
Apply the foam tape packaged with the cooktop to underside of
the cooktop along the perimeter before installing. See Fig. 3.
Important: For solid surface material installations such as Sure l l ™
®
and Corian , consult with solid surface manufacturer. Apply heat
reflective tape such as Scotch
around the cutout so that it folds over on the top and sides. DO
NOT WRAP THE TAPE UNDERNEATH THE COOKTOP. Be sure
the tape extends beyond the outermost flange of the cooktop. All
corners should be covered with tape. See Fig 3.
2. Attach Brackets to the Cooktop
Attach clamps of the hold-down brackets packaged with the cook-
top to the rough-in box. Use the washer and screws provided. See
Fig. 4.
3. Install the Cooktop
Insert cooktop into the cutout. Adjust hold-down brackets to de-
sired position and tighten screws to rough-in box. Insert adjusting
screw into clamp and secure cooktop to countertop. See Fig. 4.
Important: For solid sur face material installations: Insert a wooden
block between the end of the screw and the bottom of the coun-
tertop. Do not overtighten adjusting screw. See Figure 4. Trim ex-
cess aluminum tape around cooktop flange.
4. Connect Gas Supply
The gas inlet to the unit is located at the right rear of rough-in box.
See Figure 5. After installing a gas shut-off valve in an easily acces-
sible location under the unit (see Figure 6), install the pressure
regulator (supplied) to manifold pipe using Teflon
of manifold pipe. To prevent possible damage to the gas pressure
regulator, install it after the rough-in box is in its permanent posi-
tion.
CAUTION: Do not attempt any adjustment of the pressure regu-
lator, except conversion to propane.
Connect the gas supply line to the unit pressure regulator using a
1/2" flex gas line connector between wall shut-off valve and pres-
sure regulator. (See complete procedure in Figure 6.)
®
Aluminum Foil Tape #425 or #427
®
tape on threads
Continued next page
Figure 3
Counter cutout – solid surface
countertops
Figure 4
Attaching hold-down brackets
Figure 5
Rough-in Box area.
Figure 6
Gas and electrical location.
PAGE 3
Cutout shows location
of Aluminum Reflective Tape
Heat Reflective Tape
Section "A - A"