MSA 360S Guia Del Propietario página 6

c. If it fits with no
helmet rise
and no gap,
no adjustment
is needed.
2. To adjust headband, turn helmet
over and pull front headband
toward center of helmet. This will
disengage the Velcro hook and
loop and allow the front headband
to be lowered or raised. Once
adjusted, press the Velcro material
together again and recheck the fit
as in step 1.
EYE PROTECTION (FACESHIELD
OR GOGGLES)
1. To raise or lower the faceshield,
loosen the knobs on both sides of
the faceshield brackets.
2. Adjust the faceshield and tighten
the knobs.
3. The material has been selected for
its impact and penetration resist-
ance as well as its premium optical
clarity. The lens will scratch and
smoke stain in normal firefighting
use. Removal of light scratching
and smoke stains can be achieved
through the use of MSA
CairnsHELMETS Scratch Remover
& Polish (#R1).
Use adequate eye protection.
Removal of goggles or faceshield
voids the helmet's NFPA certifica-
tion. Use ONLY a polyarylate
TAL 4011 (L) Rev. 9 - 10043529
DONNING
WARNING
faceshield (S905) or goggles when
using a helmet with a 6" high front
to maintain NFPA compliance.
Failure to use adequate eye protec-
tion can result serious personal
injury or death.
MSA CairnsHELMETS GOGGLE
SYSTEM (ONE-TIME ADJUSTMENT)
1. Don the helmet according to nor-
mal wear instructions (chinstrap
and ratchet adjusted) and using
both hands pull the goggle out in
front of you and then down toward
your face.
2. The goggle is in
the correct posi-
tion when it is
comfortable with
little or no gaps.
3. To adjust the straps, slide the strap
webbing through the lens and
frame.
4. To tighten (increase pressure on
the face) pull the straps through
the slide buckle.
5. To loosen (reduces pressure on
face) loosen straps on sliding
buckles and strap toward goggle.
NEVER use any abrasive cleaners or
solvents on goggles or faceshield.
Clean with mild cleaners and a soft
cloth to avoid damage.
6
CAUTION