Korona 81102 Manual De Instrucciones página 23

BEFORE FIRST USE
• Remove all packaging material and check whether the appliance is complete and that all accessories are
included.
• Fully unwind the power cord.
• Clean the appliance as described under Cleaning and Care.
If any items are damaged or missing, contact your dealer or customer service.
Warning: Plastic bags are a danger to toddlers and babies, therefore keep them away to avoid
suffocation.
ASSEMBLY
1. Insert the castor wheels (16) into the designated holes of the base (15).
2. Place the base (15) on an even an stable surface.
3. Remove the the mounting nut from the fan body (14) (underneath).
4. Insert the fan body (8) into the base (15) and securely attach the fan body (8) to the base (15) by fastening
the mounting nut (14) of the fan body (8) underneath the base.
Make sure that the fan body is securely attached!
5. Unscrew the fixing knob (11) at the back of the appliance byturning it anti clockwise and insert the pole
of the motor unit (7) into the fan body(8).
Make sure that the front of the motor unit is facing the front of the fan base.
6. Tighten the fixing knob (11) by turning it clockwise.
7. Unscrew the blade fastener (2a) and rear grill mounting nut (1a) from the shaft of the motor unit (7).
8. Position the rear grill (1) over the shaft against the front of the motor unit with its handle at the top. Ensure
that the locating pegs on the motor unit (7) are correctly inserted into the holes of the rear grill (1).
9. To secure the rear grill (1), re-attach the mounting nut (1a) to the shaft of the motor unit (7) and fasten it..
10. Push the fan blade (2) onto the motor shaft and make sure that it is properly positioned.
11. To secure the fan blade (2), srew on the blade fastener (2a) and turn it in the directions of the marking
(close) until it is firmly tightened
12. Attach the mist plate (4) onto the front grill (3) and secure it with the included screws.
Make sure that the end of the hose connector is pointing downward.
13. Loosen the srew (6) of the safety ring (6) attached to the rear grill (1).
14. Align the front grill (3) inside the safety ring (6) and position the front grill (3) against the rear grill (1).
Secure front (3) and rear grill (1) by tightening the srew (6) of the safety ring (6).
Note: Always fasten the safety screw of the safety ring to ensure that the grill is properly assembled!
15. Attach the water hose (5) onto the hose connector of the mist plate (4).
FILLING THE WATER TANK WITH WATER
Always make sure that the appliance is not connected to the mains when filling the water tank.
Make sure that the appliance is standing upright and placed on a flat and stable surface.
1. Open the safety nut (12) of the water tank and carefully remove the water tank (13) from the appliance.
Instruction Manual
ENGLISH
23