Handle Assembly - Reese 30892 Manual Del Usario

FOR INSTALLATION WITH
M5 MOUNTING LEGS
1. Slide handle over the bar as shown in figure 2, and securely tighten with carriage bolts, lock washers and nuts with M13
wrench. Handle should be snug.
1. Fasteners and assembly instructions are included with the M5 Leg Structure, sold separately.
2. For height adjustment, the unit should be set to have a minimum of 6" clearance between the truck bed rail and the bottom
of the trailer. This unit has 3 possible attachment locations, with 4" of overall adjustment.
NOTICE: Failure to adjust and monitor gap between truck bed and trailer may lead to property
3. For added clearance to the truck cab, see page 7.
4" of total adjustment
1. In order to ensure quiet performance, apply grease per page 3, figure 9A. Place head unit on top of center section. Insert
pull pin as shown in figure 6, and secure with spring clips. Both sides required.
2. Inspect through sight holes on top of head unit to make sure clips are assembled correctly, as shown in figure 7.
WARNING: Failure to install both pull pins and clips may lead to property damage, injury, or death.
Pinch point areas
©
2017 Horizon Global America Inc.
Product Instructions
M5 HEAD & CENTER SECTION
FIG. 2
Center Section Attachment to Legs
Head Attachment to Center Section
CAUTION: Avoid putting any body parts in pinch point areas (Fig 5)
FIG. 5
ASSEMBLY

Handle Assembly

FIG. 4
FIG. 6
Page 2 of 33
FIG. 3
x 2
Sight Holes
FIG. 7
30884N 10/25/2017
Part Number:
30892 & 30884
damage.
x 2
Rev. A