Relay Configurations - ISEO Zero1 THESIS 2.0 Manual Del Usuario

4. RELAY CONFIGURATION
If the lock is used in a local setting (single door), it is possible to configure the relays using If the lock is used in a local setting (single door), it is possible to configure the relays using
the jumpers included in order to obtain one of the following signals: the jumpers included in order to obtain one of the following signals:
"SECURED DOOR STATUS" (bolt out and door closed)
Note: this setting has already been preset by the manufacturer in all the locks
that use the "standard" setting software.
"MOTORISED DOOR OPENER COMMAND" (with bolt in, 1 second pulse)
Cut power, insert jumper JP1 as shown and restart power.
GB
1-15