How To Operate Your Ceiling Fan - Fanimation The Breckenfield FP7951 Serie Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

How to Operate Your Ceiling Fan

1.
Restore electrical power to the outlet box by turning
the electricity on at the main fuse box (Figure 1).
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
2.
To make fan operational, install the two 3-volt
batteries in hand-held remote transmitter, (if not using
for long periods of time, remove batteries to prevent
damage to transmitter). Store the remote away
from excessive heat or humidly (Figure 2).
3.
The 5-button hand-held remote transmitter includes
buttons for high, medium and low fan speeds as well
as buttons for fan off and light on/off. Infinite light levels
are available by holding the light on/off button
(Figure 3).
If airflow is desired in the opposite direction, turn
4.
the fan off and wait for the blades to stop turning.
Then slide the reverse switch on top of motor
assembly to the opposite position and turn fan on
again (Figure 4).
Reverse Switch Information
Season
Rotation Direction
Summer
Counter-Clockwise
Winte r
Clockwise
Switch Position
Left
Right
13
Figure 1
3V, CR2032
BATTERY
2 PCS
REMOTE
CONTROL
Figure 2
5-BUTTON
REMOTE
CONTROL
Figure 3
Figure 4
MAIN FUSE BOX
REVERSE
SWITCH

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido