Unpacking Instructions - Fanimation The Breckenfield FP7951 Serie Manual Del Propietário

This Manual is Designed to Make it as Easy as Possible for You
to Assemble, Install, Operate, and Maintain Your Ceiling Fan
Tools Needed for Assembly
• One Phillips head screwdriver
• One stepladder
• One ¼˝ blade screwdriver
▲WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 4). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in fi nding your place should you be interrupted.
▲WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 16)
Canopy Screw Cover
Hanger Bracket
Motor Coupling Cover
Assembly
Ceiling Canopy
Downrod/
Hanger Ball Assembly
Light Plate Assembly
• One wire stripper
• Three wire connectors
(supplied)

Unpacking Instructions

Assembly
Assembly
Fan Motor
Assembly
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
• Fan Motor Assembly
• Hanger Bracket Assembly
• Downrod/Hanger Ball Assembly
• Ceiling Canopy
• Canopy Screw Cover Assembly
• Motor Coupling Cover Assembly
• Light Plate Assembly
• Housing Ring Assembly
• Socket Plate Assembly
• Blade Holder Set
• Blade Set
• Glass Assembly
• Minican Light Bulb
• Remote Hand Held
• Receiver Unit
Housing Ring Assembly
Hand-Held Remote
Socket Plate Assembly
Glass Assembly
4
Materials
Wire Size A.W.G.
14
12
• Hardware bag:
– Eleven ¼˝-20 x 14 mm
(blade holder to fan motor hub)
screws with lockwashers
– Sixteen 3 /
16
to blade holder) washer-head
screws
– Fiber Washers
– Phillips Screwdriver 4˝
– Wire Nuts
– Balance Kit
Blade Holder Set
Minican
Light Bulb
TR24 Receiver
Unit
Hardware Bag
-24 x 7.5 mm (blade
Blade Set