How To Assemble Your Ceiling Fan - Fanimation The Breckenfield FP7951 Serie Manual Del Propietário

How to Assemble Your Ceiling Fan

1. Remove the hanger ball portion from the downrod
/hanger ball assembly by loosening the set screw
in the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and
hanger ball for reinstallation in Step 8 (Figure 1).
2. Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
reinstallation in Step 4 (Figure 2).
3. Loosen the two set screws in the downrod support.
Route black, blue and white lead wires through the
downrod (Figure 3).
4. Position downrod support and align the clevis pin
holes in both parts. Install the clevis pin and secure
with the hairpin clip.Tighten the two set screws
and locking nuts in the downrod support (Figure 4).
5. Remove one of the three screws in the support
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws.
Assemble the light plate assembly to the support
bracket using the two keyslots in the socket plate.
Replace the third screw and securely tighten all three
screws (Figure 5).
Downrod
Set Screw
Hairpin
Clip
Downrod
Downrod Support
Set Screws and
Locking Nuts (2)
Screwdriver
Support
Bracket
Light Plate
Assembly
6
Pin
Hanger Ball
Figure 1
Clevis Pin
Figure 2
Black, Blue and
White Leads
Downrod
Figure 3
Clevis Pin
Hairpin Clip
Figure 4
Fan Motor
Assembly
Screw (3)
Figure 5