How To Wire Your Ceiling Fan - Fanimation The Breckenfield FP7951 Serie Manual Del Propietário

WARNING
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before hanging
(Figure 1).
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice, as
it must be grounded for safe operation.
NOTE: The hand-held remote included with this fan
has 16 different code combinations. To prevent
possible interference from or to other remote units,
simply change the combination code in your
transmitter and receiver.
1. To set the transmitter code, remove battery cover
by pressing firmly below arrow and sliding cover
off. Slide code switches to your choice of up or
down position. Factory setting is all up. Do not use
this position. With a small screwdriver or ball point
pen slide firmly up or down. Replace battery cover
on the transmitter (Figure 2).
2. To set the receiver unit code, slide code switches
to the same positions as set on your transmitter
(Figure 3).
3. Slide the receiver unit into the open end of the
hanger bracket (Figure 4).

How to Wire Your Ceiling Fan

REMOTE
TRANSMITTER
UNIT DETAIL
TRANSMITTER CODES
RECEIVER
UNIT
DETAIL
9
MAIN FUSE BOX
Figure 1
Figure 2
Figure 3
RECEIVER UNIT
HANGER BRACKET
Figure 4