ISOtunes Noise-Isolating Manual De Usuario página 5

Bluetooth Pairing
Press and hold the MFB until the indicator light flashes red AND blue
interchangeably, or until you hear "Pairing" through the speakers. Your
ISOtunes
™ must be within 3 feet of the device you're pairing with.
Search for and select "ISOtunes" in the Bluetooth
device. You will then hear "Paired. Your phone is connected." through the
speakers. If prompted, use input code "0000" to pair.
After powering off and powering back on again, ISOtunes
automatically reconnect with its paired device, if in range.
To delete a pairing record, press and hold both the Volume Up (+) and
Volume Down (-) buttons until the red and blue LED light flashes twice at
the same time. Then, when prompted by a "beep", press and hold the MFB
for 3 seconds or until the devices are disconnected.
settings of your pairing
®
will
™
Recharging
We recommend charging your ISOtunes
included USB charger to connect to the micro-USB port on the controller
of the headphones. A red LED indicates your headset is charging, while a
blue LED indicates the charging has finished. When the battery is low, the
indicator light will flash red, accompanied by periodic beeps. ISOtunes
supports iOS Bluetooth battery level indicator.
®
Audio Control Functions
Volume Adjustments: Use the Volume Up (+) and Volume Down (-) buttons
to adjust the volume.
Play and Pause Music: Press the MFB once; or, separate/connect the
magnetic earphones; or, control on your Bluetooth
Forward/Backward Song Selection: Press and hold the Volume Up (+)
button for 2 seconds to skip to the next song. Press and hold the Volume
Down (-) button for 2 seconds to return to the previous song.
™ fully before its first use. Use the
™
-enabled device.
®