LUCCI Air AIRFUSION BANKSIA DC Manual De Instrucciones De Instalación página 11

Banksia Fan Installation Instructions

Press the button to activate the fan timer fuction, the fan will turn off after running 1 hour / 4 hours / 8
hours. To cancel the timmer fucntion, just press the fan on/off button.
: LED INDICATOR (6):

Indicates the fan button has been pressed and activated.

Flashing to indicates the battery at low level.
REPAIRING THE FAN RECEIVER AND REMOTE
Note: The pairing of the transmitter and receiver have been paried at the factory, when ceiling fan is
installed, pairing the fan receiver and remote is NOT required.
Should the remote and receiver lose control after installation or during use, the pairing of the remote and the
receiver must be repaired. Below are the operating symptoms and method to repair the pairing of the DC
ceiling fan remote and receiver.
Issues:

Loss of control - Fan is only running at high speed after installation

Loss of control - No reverse function after installation

Loss of control - Remote cannot communicate with the receiver
Solution:

Switch off the main power to ceiling fan.

Press and hold the "
power to the receiver of the ceiling fan. The fan will have "bee, bee" sound to indicate the paring process
is activated.

Turn ON and change the speed of the ceiling fan by the transmitter to check the operation and successful
paring.
INSTALLING THE TRANSMITTER HOLDER
Install the holder with the two screws provided.
10 | P a g e
: FAN TIMER BUTTON (5):
" button on transmitter for 5 seconds within 30 seconds of switching the
Fig. 11