Makita XCU03 Manual De Instrucciones página 10

1. Lever
2.
the saw chain tension.
1.
3. Turn the lever counterclockwise until the sprocket
cover comes off.
1
1. Lever 2. Sprocket cover
4. Remove the sprocket cover then remove the saw
chain and guide bar from the chain saw body.
To install the saw chain, perform the following steps:
1. Make sure the direction of the chain. The arrow
mark on the chain shows the direction of the chain.
2. Fit in one end of the saw chain on the top of the
guide bar and the other end around the sprocket.
1
1
2
10 ENGLISH
1. Sprocket
3. Rest the guide bar in place on the chain saw.
4.
1.
5. Place the sprocket cover on the chain saw so that
guide bar.
3
1. Sprocket cover 2. Guide bar 3. Hole
6. Turn the lever clockwise fully and a quarter turn
7.
8. Turn the lever clockwise until the sprocket cover is
secured then return it to the original position.
1
1
1
2