Makita XCU03 Manual De Instrucciones página 11

1. Lever 2. Sprocket cover
Adjusting saw chain tension
CAUTION:
Carry out the procedure of install-
ing or removing saw chain in a clean place free
from sawdust and the like.
CAUTION:
Do not tighten the saw chain too
much.
cause breakage of saw chain, wear of the guide bar
CAUTION:
A chain which is too loose can
jump off the bar and it may cause an injury
accident.
The saw chain may become loose after many hours
of use. From time to time check the saw chain tension
before use.
1. Press and fully open the lever until it clicks. Turn it
counterclockwise a little to loosen sprocket cover lightly.
1
1. Lever 2. Sprocket cover
2.
to loosen, turn to the "+" direction to tighten. Tighten the
guide bar rail as illustrated.
1
2
2
1.
3. Keep holding the guide bar lightly and tighten the
sprocket cover. Make sure that the saw chain does not
loose at the lower side.
4. Return the lever to the original position.
1. Lever 2. Sprocket cover
side of the bar.
OPERATION
Lubrication
Saw chain is automatically lubricated when the tool is in
operation. Check the amount of remaining oil in the oil
tank periodically.
remove the oil tank cap. The proper amount of oil is 200
cap is tightened securely.
11 ENGLISH
1
2
3
2. Guide bar 3. Saw chain
1
2