Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DOOR PANEL INSTALLATION
F
ix the door panel.
Face the door panel to the wall by placing the top at 1,65m. height. Drill two holes of
6mm. diameter, one on the top and one on the bottom. The bottom one is located
at the left side of the front plate fixing bolt. Use the supplied screws and wallplugs.
Once the door panel base has been fixed to the wall, insert the installation wires through
the big hole. Insert the sound module in the fixing guides and wire it as it's shown
on the installation diagram. Place the light socket in its original position.
Place the card name before to close the door panel.
If after starting the system it's considered that the audio volume isn't correct, proceed with
the necessary adjustments.
Fix the front plate to the panel base,
by using the supplied screw and key.
15
16
f
To open the telephone insert
a plain screwdriver into the slots and
rotate it as shown.
Close the telephone as shown on the picture.
Once the telephone is closed, connect the handset
using the telephone cord and put it on the craddle.
TELEPHONE INSTALLATION
D
escription of the T-722VD telephone.
b
a.
Telephone handset.
d
b.
Speaker grille.
a
c.
Microphone hole.
d.
Subjection hole.
e.
Telephone cord connectors.
c
f.
Door release push button.
g.
Contact free additional push button.
e
h.
Call volume regulator.
i.
Hook switch.
Avoid to place the telephone near to heating sources,
in dusty locations or smoky environments.
The telephone can be fixed using an electrical embedding
box or directly on the wall, as shown on the picture.
If the telephone will be installed directly over the wall,
drill two holes of Ø6mm. on the specified positions,
using 6mm. wallplugs and Ø3,5 x 25mm. screws.
Pass the installation wires through
the corresponding hole and
connect them as shown on the
installation diagrams.
g
h
i
e
Publicidad
Tabla de contenido
