Door Panel Installation; System Characteristics; System Operation; Starting Recommendations - golmar 295 Serie Manual De Instalación

INTRODUCTION
First of all we would like to thank and congratulate you for the purchase of this product
manufactured by Golmar.
The commitment to reach the satisfaction of our customers is stated through the ISO-9001
certification and for the manufacturing of products like this one.
Its advanced technology and exacting quality control will do that customers and users enjoy with the
legion of features this system offers. To obtain the maximum profit of these features and a properly wired
installation, we kindly recommend you to expend a few minutes of your time to read this manual.

SYSTEM CHARACTERISTICS

Audio system with 4 + N wires installation.
Just 1 TF-104 transformer (12Va.c., 1.5A).
Electronic call with acoustic acknowledgement signal.
a.c. lock releases activation.
Up to three telephones in the same apartment.

SYSTEM OPERATION

To make a call the visitor should press the push button corresponding to the apartment he wishes
to contact. An acoustic tone will be heard confirming the call as the push button is pressed. At
this moment the call will be received at the telephone in the dwelling.
To establish communication pick up the telephone handset.
To open the door, press the door release push button at any moment.

STARTING RECOMMENDATIONS

Do not use excessive force when tightening the transformer connector screws.
Install the equipment without the power connected. Disconnect from power before any system
modification. Check that the input voltage is lower than 230Va.c.
Before to connect the system, check the connections between door panel and telephones, and
the transformer connection. Do always follow the enclosed information.
21 22
E
mbedding box positioning.
1650
The upper part of the door panel should be placed at 1,65m. height roughly. The hole dimensions
will depend on the number of door panel modules.
The door panel has been designed to be placed under most of the environmental conditions.
However it's recommended to take additional cautions like rainproof covers.
Break the bottom flange to pass the cables through. In case of door panels

DOOR PANEL INSTALLATION

1850
1450
3
Modules 1 2
420 mm.
W 140 280
235 mm.
H 235 235
57 mm.
D 57 57
P
with more than one embedding box, break the side flanges and
attach the embedding boxes using UC junctions.
reparing the cables entry.