Door Panel Installation; Embedding Box Positioning - golmar T5000ML Manual De Instalación

DOOR PANEL INSTALLATION

E
mbedding box positioning.
1650
The upper part of the door panel should be placed at 1,65m. height roughly.
The hole dimensions are: 125(W) x 140(Al) x 57(D) mm.
The door panel has been designed to be placed under most of the environmental conditions.
However it's recommended to take additional cautions like rainproof covers. To obtain
a good quality picture on video door entry systems, avoid direct incidence from light sources.
Break the bottom flange
to pass the cables through.
59
1850
1450
P
reparing the embedding box.
Pass the wiring through the hole made in
the bottom part of the embedding box.
Level and flush the embedding box.
Once the embedding box is placed,
remove the protective labels
from the attaching door panel holes.
60
DOOR PANEL INSTALLATION
A
ssembling the EL500 microprocessed circuit.
The EL500 circuit is to be assembled on the top
of the embedding box. Insert the circuit in
the top flanges of the embedding box (1).
Push-in the circuit in the bottom flanges (2)
by pressing the pcb board.
2
Select a direction to open the door panel; this selection should ease
the door panel wiring.
The opening direction will be settled through the hinges position,
that must be passed through the header clips as shown.
For example, if the hinges are placed on both clips of the lower
header, the door panel will open downwards; if they are placed
on the right clips of both headers, the door panel will open to left.
To hold the door panel on the embedding box,
insert the hinges in the embedding box lockers
as shown.
1
H
old the door panel on the embedding box.
Link the sound module with the EL500
microprocessed circuit by using
the supplied flat cable.