Rowenta FOCUS Instructivo De Operación página 13

Problems
Brown streaks come
through the holes in
the soleplate and
stain the linen.
Iron is leaking.
If you are unable to trace the cause of the fault, contact an official Rowenta
Customer Service Centre. The addresses are shown in the enclosed service
centre address list. Helplines listed at the front of this leaflet.
Further hints and tips are obtainable from our homepage: www.rowenta.ca.
Subject to modifications !
* depending on model
Cause
Your linen is not rinsed sufficiently
or you have ironed a new garment
before washing it.
Use of starch.
Pure distilled / demineralized or
softened water is
being used.
Overuse of shot of steam button.
Soleplate temperature too low .
Ensure linen is rinsed thoroughly
to remove any soap deposits or
chemicals on new garments
which may be sucked by the iron.
lways spray starch onto the
reverse side of the fabric to be
ironed and clean your iron
soleplate.
Only use untreated tap water or
mix half tap water with half
distilled/demineralized water. Use
the Self Clean function and clean
your iron.
llow more time between each
shot.
Set the temperature control to a
higher temperature.
9 9
Solution