Filling The Water Tank; Setting The Temperature; Dry Ironing - Rowenta FOCUS Instructivo De Operación

USE
4 • Filling the water tank
IMPORT NT Before filling the water tank, unplug the iron and set the steam
control to dry position
Tilt the iron. Open the filling inlet (fig.6). Pour in water up to the max mark
(fig.7). Close the filling inlet (fig.8) and return the iron to the horizontal position.
5 • Setting the temperature
Set the iron temperature to suit the type of material using the temperature
control dial (fig.3).
Temperature control*: The temperature control light indicates that the soleplate
is heating up. When the temperature control light goes off (fig.9), the set tempe-
rature is reached and you can begin ironing.
Ironing label
Electronic temperature control*: The traffic lights tell you whether the soleplate
has reached the selected temperature (fig.10).
YELLOW
GREEN
RED
UTO- OFF
IMPORT NT
commend that you start with fabrics to be ironed at a low temperature.
For mixed fabrics set the temperature for the most delicate fabric.
TIP lways spray starch onto the reverse side of the fabric to be ironed.
6 • Dry ironing
Set the variable steam control to
type of material (care points •, ••, •••).
* depending on model
.
Synthetic fibres, e.g. vis-
cose, polyester...
Silk, wool
Cotton, linen
The soleplate is still too cold for the selected material.
The soleplate is at the right temperature for the selected material.
The soleplate is still too hot for the selected material.
The automatic electronic cut-out* is active.
The iron takes longer to cool down than to heat up. We re-
Fabric
(fig.11) and set the temperature to suit the
5
Temperature control
•
••
•••