Connecting The Power Cord - Pioneer AVH-P4200DVD Manual De Instalación

Connecting the units

Connecting the power cord

Navigation unit
(AVIC-F220 (sold
separately)).
Please contact your dealer to
inquire about the connectable
navigation unit.
Note:
Depending on the kind of vehicle,
the function of 2* and 4* may be
different. In this case, be sure to
connect 1* to 4* and 3* to 2*.
2*
4*
Yellow (2*)
Back-up
(or accessory)
Red (4*)
Accessory
(or back-up)
Orange/white
Connect to lighting switch terminal.
Black (chassis ground)
Connect to a clean, paint-free metal location.
ISO connector
Note:
In some vehicles, the ISO connector may be divided into
two. In this case, be sure to connect to both connectors.
(AVH-P4200DVD only)
When you connect the separately sold
multi-channel processor (DEQ-P6600) to this
unit, do not connect anything to the speaker leads
and system remote control (blue/white).
4
26 pin cable (Supplied with Navigation unit)
Insert the 26 pin cable in the direction
indicated in the figure.
1*
3*
Yellow (1*)
Connect to the constant 12 V
supply terminal.
Red (3*)
Connect to terminal controlled by
ignition switch (12 V DC).
AUX jack (3.5 ø) (AVH-P4200DVD only)
Use a mini plug cable to connect with auxiliary device.
Microphone input (AVH-3200BT only)
RGB input
Fuse (10 A)
Antenna input
Connect leads of the same
color to each other.
Fuse resistor
Fuse resistor
Speaker leads
Front left 
White:
White/black: Front left 
Front right 
Gray:
Front right 
Gray/black:
Rear left  or subwoofer 
Green:
Green/black: Rear left  or subwoofer 
Rear right  or subwoofer 
Violet:
Rear right  or subwoofer 
Violet/black:
4 m
(AVH-P4200DVD only)
(AVH-
P4200DVD
only)
This product