Troubleshooting - GYS FLASH 10.36/48 PL Traducción De Las Instrucciones Originales

Translation of the original instructions
• Protections :
The GYSFLASH 10.36/48 PL has several features to protect it against short circuits and polarity reversal. It has an
anti-spark feature which prevents sparks whilst connecting the device to the battery. This charger has double insula-
tion and is safe to use with the battery in situ as it will protect the vehicle's on-board electronics.
The GYSFLASH 10.36/48 PL is equipped with an integrated temperature sensor that allows it to adapt its charging current accor-
ding to the ambient temperature in order to prevent internal electronics from overheating.
TROUBLESHOOTING, CAUSES, SOLUTIONS

Troubleshooting

1
Indicator flashes.
2
The indicator is on.
Indicator rstays on even after pressing
3
button
4
Indicator flashes.
5
Indicator stays on.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
GYSFLASH 10.36/48 PL
Causes
• Polarity reversal
• Battery voltage is too high
• Clamps in short-circuit
• Failure during charging, battery not
recoverable
• External temperature too low to
charge a lithium battery
Thermal protection
Charger in sleep mode
Charge interrupted by pressing
.
Solutions
• Check that the clamps are connected correctly
• Check that the selected voltage matches the
battery voltage.
• Change the battery and press
restart a charge.
• Charge the lithium battery in a temperate place or
press button .
Ambient temperature is too high (>50°C), cool the
room and let the charger cool down.
Press button or connect a battery to
the charger to exit sleep mode.
Press again to restart the load
EN
to
13