jbc AD 2950 Manual Del Usario página 6

ENGLISH
PROGRAMMING
The system allows you to modify and adjust the
temperature between 90 and 450ºC (190 and
840ºF). These are the factory pre-selected
temperatures:
- Minimum temperature: 90ºC
- Maximum temperature: 400ºC
In order to modify the station and tool parameters
and have access to the counters, you must hold
the SELECT key for 3 seconds. The PIN number
must be entered when you need to change a
station parameter. Default PIN number: 0105.
You will find the operation diagrams are on the
following pages.
Display messages
- HIBERNATION: Tool completely cold. Minimum
charge mode.
- SLEEP MODE: Short temperature tool (with in
200 to 280 Cº depending on tool).
- SYSTEM STOPPED
maximum available power has been exceeded
for too long. You must wait and the station will
automatically reset.
- ERROR SHORTCIRCUIT. Short circuit in the
system. Possible causes:
Short circuit in the cartridge, in the handpiece,...
- NO TOOL. Possible causes: use of a tool
which is not compatible with the station.
Once you correct the above mentioned causes,
the station will start working automatically.
OVERLOAD. The
Temperature Levels:
The temperature levels enable a fast access to
the pre-selected temperature stored in each
level by the user.
Up to 5 temperature levels can be configured
(which means, you can lock up to 5
temperatures), according to the working needs.
Each level corresponds to a higher temperature
than the one of the previous level, the higher
the level, the higher the temperature.
You can work with the temperature levels
activated or deactivated (by default they are
deactivated):
- Activated: you can increase or decrease the
working temperature
decreasing the level.
- Deactivated: you can increase or decrease
the working temperature manually by intervals
of 5ºC.(10ºF)
(see the program modification chart of the
station parameters)
Fume extractor accessories
For 2245 handpiece:
Ref. 0003435
Specially designed for the Advanced Series
2210 and 2245 handpieces. Easily clips onto
the handpiece and can be quickly removed for
easy maintenance.
JBC reserves the right to make technical changes without prior
notification.
5
by increasing or
For 2210
handpiece
Ref.0003450